UL Compliance

(Applies to G3 Automation Controller)  

To reduce the risk of electric shock, this equipment has a grounding type plug, that has a third (grounding) pin. This plug will only fit into a grounding type outlet. If the plug does not fit into the outlet, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. 

  

 G3 controller kits are UL approved for US and Canadian residential installation.  Prior to installation, please review the AC input requirements for your locale.


UL US (English)

UL Compliance

UL conformity requires the following in respect to the input AC power and the G3 controller system:

  1. A 120VAC receptacle shall be positioned within 6ft(1.83m) of the intended G3 installation location.
  2. The supplied AC power cord shall be routed in such a manner as to prevent it to becoming entangled in the door, moving parts of the system, or the operator.
  3. The AC power cord shall not be routed through doorways, windows openings, walls, ceilings, floors, or the like.
  4. The AC power cord shall not be secured to the building structure nor concealed behind walls, and the like.
  5. If the input AC power cord is replaced, it must meet or exceed the supplied power cord’s ratings shown:

                                                    18AWG(0.824mm), 300V, 3/C, 75̊C, Length: 6ft(1.83m) 

                                                                 UL Listed for the US and Canada.

UL Canada (French)

UL Conformité

La conformité UL exige ce qui suit en ce qui concerne la puissance AC d'entrée et le système de commande G3:

  1. Un récipient de 120VAC doit être placé à moins de 6pi(1,83 m) de l'emplacement prévu pour l'installation G3.
  2. Le cordon d'alimentation fourni doivent être disposées de manière à l'empêcher de s'emmêler dans la porte, les pièces mobiles du système, ou de l'exploitant.
  3. Le cordon D'alimentation ca ne doit pas être acheminé par des portes, des ouvertures de fenêtres, des murs, des plafonds, des planchers ou autres.
  4. Le cordon d'alimentation ne doit pas être fixé à la structure du bâtiment, ni dissimulé derrière des murs, et la comme.
  5. Si l'entrée cordon d'alimentation est remplacé, il doit satisfaire ou dépasser le cordon d'alimentation fourni est nominales indiquées:

                                                   18AWG(0.824 mm), 300V, 3/C, 75̊C, Longueur: 6ft(1.83 m)

                                                               UL listée pour les États-Unis et le Canada


FCC DECLARATION OF CONFORMITY

 


(Applies to G3 Automation Controller)


Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a commercial installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. Operation of this equipment in a residential area is more likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

           • Reorient or relocate the receiving antenna. 

• Increase the separation between the equipment and receiver. 

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.