This installation covers the mechanical and automation system installation of our Generation 2 automation system. The G2 controller is much smaller than our G1 design and can be used on all single motor one-way and bi-part installations. The controller is mounted withing 6 feet of the controller using the included cable.
* The G2 installation manual covers programming the controller with firmware version 123. If you have an older G2, it may have an older version of the firmware possibly 316, 317 or 318. If that is the case, in addition to the full installation manual you should also download the "G2 316-317 Legacy Programming" guide below.
Step by step programming guides for the G2 123 (current) and G2 316/317 Legacy firmware's are also available.